Metal roofing installers serving Addison, Texas
Addison Metal Roofing for Attached Homes and Low-Slope Buildings
Shared walls, short roof planes and close neighbors shape nearly every roofing decision in Addison. Permanent Metal Roofing Systems fits the town’s townhomes and zero-lot-line houses with standing seam panels, metal shingles or DECRA stone-coated steel, and installs low-slope metal systems on its offices and retail buildings. This Dallas County town is about 15 miles northwest of our Mesquite base, an easy run along LBJ Freeway. Our own crews do the installation, and the trim for each party wall, dormer and parapet is bent in our shop, so one unit can change to metal without looking out of place on its block.
- 20+ years of experience
- Lifetime limited warranty
- Free written estimates
The Houses of Addison and the Metal Roofs That Suit Them
Most Addison owners live in townhomes or zero-lot-line brick houses built from the 1980s through the 2000s, concentrated in Addison Circle and Les Lacs and surrounded by a large stock of apartments and offices. Those roofs are steep but small, chopped up by dormers, and often joined to the next unit along a common wall. After a few decades of North Texas sun, composition shingles there crack along the ridges and shed granules, and one hailstorm can damage an entire row at once. On a single unit, a metal shingle or a stone-coated steel panel reads as an ordinary shingle roof from the sidewalk. When a whole building reroofs together, one color of 1.5-inch snap lock across all the units gives the row a crisp, matching line.
Our crews work from Les Lacs and Midway Meadows to Addison Circle and the Vitruvian Park area, and on commercial roofs around Addison Airport, Addison Circle Park and the restaurant row on Belt Line Road near the Dallas North Tollway.
Weather Notes for a Addison Metal Roof
On June 13, 2012, baseball-size hail fell across the North Dallas corridor that includes Addison, while straight-line gusts from the May 28, 2024 derecho battered the same neighborhoods. A roof here has to handle both. For impact, DECRA publishes a UL 2218 Class 4 rating for its stone-coated lines, and EDCO says the same of its ArrowLine and Generations HD steel shakes. A 24-gauge standing seam panel takes a strike with less denting than a thinner 26-gauge one, though big stones can still leave cosmetic marks. Only your carrier decides whether a Class 4 roof lowers the premium. Against wind, our crews set concealed clips closer together along eaves, rakes and corners, where uplift is greatest.
- Metal roofing systems with UL 2218 Class 4 ratings available, with the documentation insurers ask for
- Photo-documented roof inspections after hail and wind
- A written, itemized scope you can share with your adjuster
See how Class 4 impact-rated metal roofing works, what to do about hail damage and insurance claims, or compare standing seam systems and stone-coated steel.
Our Metal Roofing Work in Addison, TX
For a single Addison townhome, metal shingles and stone-coated steel come first, because the unit has to sit comfortably beside attached neighbors that may keep shingles for years. Snap lock standing seam makes sense when a whole building or row reroofs at the same time and the association wants one color. On the town’s offices, restaurants and shops, mechanical lock panels seamed on the roof cover slopes as low as 1/2:12. Flashing bent in-house handles the party walls, parapets and cramped eaves that a dense block produces.
Standing Seam Roofs
Hidden-clip standing seam in 24-gauge Galvalume, aluminum, copper or zinc, with Kynar 500 finishes built for Texas sun.
Stone-Coated Steel
Steel panels coated in stone granules for the look of shake, shingle or tile, with impact ratings from the manufacturer.
Metal Shingles and Shakes
EDCO and Classic Metal Roofing Systems shingle and shake profiles in colors that suit brick and stone.
Corrugated and PBR Roofs
Ribbed panels for barns, shops and porch roofs, cut to the length of each run before they reach the site.
Copper and Zinc Roofing
Natural copper and zinc in standing seam, flat lock or diamond panels for whole roofs, bays and turrets.
Metal Roof Repair
Leaks at seams, screws, pipe boots and flashing traced and fixed on Addison metal roofs, ours or not.
Every Addison roof is priced from its own measurements. The metal roof cost guide explains which choices move the number most, from pitch and tear-off to profile and metal.
Getting a Metal Roof Approved in Addison
Addison’s attached-home communities are run by HOAs, while most of its single-family streets have no association at all. If yours has one, expect an architectural review of color and profile before work begins, and on a shared-wall building expect the board to ask how your roof will meet the neighbor’s. State law helps: a Texas Property Code provision, section 202.011, usually stops an association from barring shingles built to stand up to wind and hail that look like the shingles it already allows, last at least as long, and suit the surrounding homes. We assemble product sheets and samples for your request, and PMRS takes out the town’s building permit whenever one is needed.
Addison Coverage Snapshot
| Counties | Dallas County |
| Residents | Roughly 17,000 |
| Typical home | median value $482,000; half built in 1998 or earlier (Census ACS 2020-2024) |
| From our base | About 15 miles from Mesquite |
| Roof systems | Standing seam, metal shingles and shakes, stone-coated steel, corrugated and PBR, copper and zinc |
| Services | New roofs, replacements, repairs and hail damage documentation |
| Estimate and warranty | Free, measured and itemized in writing; lifetime non-prorated limited warranty on PMRS standing seam, transferable one time |
The PMRS Difference in Addison
- HOA approval packages with product sheets and color samples.
- Metal roofing specialists since 2006, with our own crews on every job.
- Panels and trim formed by PMRS in Mesquite or on site, so every piece fits the roof it was made for.
- Written, itemized estimates that spell out panel, gauge, finish, underlayment and trim.
- Our own installation crews, scheduled from our Mesquite office, never subcontractors.
Addison Metal Roof Questions
My Addison townhome shares a wall with a shingled unit. Can mine still be metal?
In most cases, yes. The detail that matters is the joint along the shared wall, where your metal meets the neighbor’s shingles. We bend a custom flashing and divider for that seam so water from each roof stays on its own side. Metal shingles or stone-coated steel usually look most natural next to a shingled unit, and your HOA will want to approve the color and profile first.
Which metal roof suits a low-slope office building near Addison Airport?
Mechanical lock standing seam, in most cases. Our 1.5-inch HD and 2-inch mechanical lock panels work down to a 1/2:12 slope, and the seams are folded shut on the roof so ponding water cannot work through them. On pitches of 3/12 and under we lay a high-temperature underlayment first. If the panels are seamed to specification, the owner may also purchase an optional weather-tightness warranty from a third party.
How does PMRS handle a roof job on a tight Addison townhome block?
With planning before the crew shows up. Many attached homes here have little driveway space, so we agree on where material, the trailer and the debris container will sit. Panels are formed to length at our Mesquite shop or on site with our mobile roll former, then carried up in measured bundles. We protect neighboring units during tear-off and clean the block before we leave.
Does PMRS repair metal roofs in Addison that another company installed?
Yes. We trace leaks at seams, screws, pipe boots and flashing on standing seam, PBR, corrugated and metal shingle roofs, whoever put them on, and explain the cause before we fix it.
More Cities Near Addison
- Carrollton (4 mi)
- Farmers Branch (5 mi)
- Richardson (6 mi)
- University Park (8 mi)
- Plano (9 mi)
- Highland Park (9 mi)
The full list lives on our DFW service areas page, and the office details are on our Mesquite location page.
Price a Metal Roof for Your Addison Property
Send the form for a written Addison estimate, or call (469) 466-2421 and talk it through with the company that forms and installs the roof.