Metal roof installation in Rockwall, TX

Rockwall Metal Roofing From The Harbor to Breezy Hill

During the April 11, 2016 storm, grapefruit-size hail, about 4 inches across, was reported on Eastshore Road in Rockwall, and the city has since seen 2-inch stones and derecho winds near 80 mph. Permanent Metal Roofing Systems plans Rockwall roofs around that record, fitting each home with the metal that suits it best, from standing seam to stone-coated steel and metal shingles, and putting standing seam or PBR on commercial buildings near the I-30 crossroads. Rockwall, founded in 1854 and now the county seat, faces Lake Ray Hubbard from its eastern bank, about 14 miles from our Mesquite office.

  • 20+ years of experience
  • Lifetime limited warranty
  • Free written estimates

Matching a Metal Roof to Rockwall Homes

Most Rockwall neighborhoods, Stone Creek and Breezy Hill among them, were built from the 1990s on with brick-and-stone-veneer houses of one or two storeys under composition shingles. Along the water near The Harbor and Chandlers Landing, the houses are custom builds, and the blocks around the historic courthouse square date mostly from the 1950s to the 80s. Hail and sun age subdivision shingles fast; a stone-coated steel or metal shingle roof holds onto the familiar look while adding impact resistance. Lakefront roofs take wind straight off the water, and there either type of standing seam, snap lock or mechanical lock, holds far better than shingle tabs once its clips are set closer together. Near the square, the simple older roofs take straight snap lock runs.

We serve Chandlers Landing, Breezy Hill, The Harbor at Rockwall and Stone Creek, along with homes and businesses near the historic Rockwall County Courthouse square and around the junction of I-30 with SH 205 and SH 66.

Why Rockwall Roofs Take a Beating

Rockwall’s storm record is unusually rough. The April 11, 2016 storm produced 3-inch and grapefruit-size hail in the city. On June 11, 2023, observers reported 2-inch stones roughly a mile northeast of downtown and golf-ball hail elsewhere in town. Less than a year later, the May 28, 2024 derecho hit with winds approaching 80 mph and half-dollar hail, and hundreds of homes across the county were damaged. Against hail, consider coverings rated Class 4 under UL 2218 by their makers, such as DECRA stone-coated steel or EDCO steel shakes, or 24-gauge standing seam to hold down cosmetic dents; carriers set their own credits. Against wind, concealed clips go closer together at eaves, rakes and ridges.

  • Honest advice on what Class 4 does and does not cover, including cosmetic denting
  • Dated storm-damage photos and measurements
  • No pressure and no door-to-door storm chasing

See how Class 4 impact-rated metal roofing works, what to do about hail damage and insurance claims, or compare standing seam systems and stone-coated steel.

Metal Roofing Systems We Install in Rockwall

Rockwall work falls into three groups. In the newer subdivisions, the job is meeting HOA color rules, which stone-coated steel and metal shingles do with a wide range of matched colors. On the lakefront near The Harbor and Chandlers Landing, the job is holding a roof down in open wind, which is where snap lock and mechanical lock standing seam earn their place. Around the courthouse square and the I-30 crossroads, commercial owners can have standing seam or PBR roofs installed, with coping and flashing formed in our shop.

Standing Seam Roofs

A clean, modern roof with no exposed screws to back out, available with Class 4 impact-rated assemblies.

Stone-Coated Steel

DECRA shake, shingle and tile profiles that keep a traditional look on Rockwall homes in HOA neighborhoods.

Metal Shingles and Shakes

Interlocking metal shingles that shed hail and wind and keep a cedar, slate or tile appearance.

Corrugated and PBR Roofs

Corrugated and PBR panels for homes, shops, barns, carports and porches around Rockwall.

Copper and Zinc Roofing

Natural copper and zinc in standing seam, flat lock or diamond panels for whole roofs, bays and turrets.

Metal Roof Repair

Loose fasteners, failed sealant and storm-damaged panels repaired or replaced one section at a time.

How much will it cost? That depends on size, pitch, profile, metal and tear-off, so we measure first. Our cost guide walks through the seven factors.

Approvals Before a Rockwall Metal Roof Goes On

Nearly every Rockwall subdivision built after 1995 has an HOA with written guidelines for exterior materials and roof colors. The Texas Property Code, at section 202.011, stops a board from rejecting a hail- and wind-resistant or energy-saving shingle if it looks like the approved roofs, will last longer and matches their quality or better, while still letting the board control color and appearance. In practice, picking an approvable color is the real hurdle, so we bring PVDF and stone-coated samples matched to your guidelines. After approval we file the City of Rockwall’s permit whenever one is required.

Working in Rockwall: The Basics

CountiesRockwall County
ResidentsRoughly 54,000
Typical homemedian value $412,000; half built in 2003 or earlier (Census ACS 2020-2024)
From our baseAbout 14 miles from Mesquite
Roof systemsStanding seam, metal shingles and shakes, stone-coated steel, corrugated and PBR, copper and zinc
ServicesNew roofs, replacements, repairs and hail damage documentation
Estimate and warrantyFree, measured and itemized in writing; lifetime non-prorated limited warranty on PMRS standing seam, transferable one time

What a PMRS Roof Means for Rockwall Owners

  • Our own installation crews, scheduled from our Mesquite office, never subcontractors.
  • A lifetime non-prorated limited warranty on PMRS standing seam roofs, transferable one time. See our warranties.
  • Class 4 impact-rated systems and the product documentation insurers ask for.
  • Your deductible stays your deductible. Texas law bars roofers from covering it, and we comply.
  • HOA approval packages with product sheets and color samples.

Metal Roofing in Rockwall: Common Questions

How do I get a metal roof color past a Rockwall HOA?

Begin with your subdivision’s written guidelines; many name color families instead of brands. At the estimate we hold our PVDF charts and stone-coated samples up to that list, narrow it to the closest matches and put the submittal together. Most approved palettes, from earth tones to weathered wood and charcoal, have a counterpart in both metal systems.

Does standing seam make sense on a Chandlers Landing lake home?

Yes, once the HOA approves it. Roofs that face the lake catch steady, open wind, and standing seam holds its panels with hidden clips rather than exposed screws that can loosen. Clip spacing shrinks toward the edges and corners, where uplift is greatest. The PVDF paint resists fading in full sun, and on our standard PVDF colors the coil coater’s finish warranty runs 40 years.

Do the older homes near the Rockwall square suit metal?

They do. Houses near the historic square, mostly built from the 1950s to the 80s, have plain rooflines that suit snap lock standing seam or metal shingles. After stripping the old roof we repair any weak decking and put down high-temperature underlayment, and the chimney flashing and caps are shaped in our shop to fit the older masonry.

What should Rockwall owners do first after a hailstorm?

Photograph the roof and any ceiling stains, then call us before signing anything. We document the damage with dated photos and measurements and write a scope for your adjuster. Your carrier decides coverage, and Texas law makes the deductible yours to pay.

Neighboring Communities on Our Route

The full list lives on our DFW service areas page, and the office details are on our Mesquite location page.

Book Your Free Rockwall Roof Estimate

A Rockwall estimate costs nothing and comes itemized, with straight answers on panel profile, color and timing.