Sunnyvale, TX metal roofs, formed and installed by PMRS
Sunnyvale Metal Roofing for Estates, Shops and Barns
Only about 5 miles of road separate Sunnyvale from our Mesquite office, so it is one of the closest towns on our list. Large-lot homes there get standing seam that we form and install ourselves, or stone-coated steel, metal shingles and metal shakes from Permanent Metal Roofing Systems. Out on the acreage, barns, shops and equipment sheds take corrugated or PBR panels that we roll-form ourselves, with trim bent to match. The town lies in eastern Dallas County on the US-80 corridor, with Lake Ray Hubbard along its east edge, and metal already covers a growing share of its roofs.
- 20+ years of experience
- Lifetime limited warranty
- Free written estimates
Roof Types We See Around Sunnyvale
Custom homes on big lots are what Sunnyvale is made of. Most of them are brick and stone two-storeys, each on an acre or more, built over the three decades since the 1990s. Their roofs are usually complicated, with multiple hips, valleys and tall gables, and under composition shingle it is the valleys and ridges that show heat and hail damage first. Stoney Creek and Long Creek estates make strong metal candidates. On the main house, our usual suggestion is 1.75-inch snap lock standing seam, or a stone-coated shake where texture flatters the stonework. Elsewhere on the lot, PBR can roof the detached shop or barn.
We serve Homestead, Long Creek, the Town Center area and Stoney Creek, along with acreage off US-80, homes close to Samuell Farm and properties toward Lake Ray Hubbard on the east side of town.
Sunnyvale Hail, Wind and Heat: What a Roof Faces
The December 26, 2015 tornado cut its track through Garland and Rowlett just north of Sunnyvale, and the town sat inside the zone hit by hail on April 8, 2024. With acreage open on every side, both hazards count. Class 4 ratings under UL 2218 come from the makers: DECRA for its stone-coated steel, EDCO for its ArrowLine and Generations HD steel shakes. In standing seam, a 24-gauge panel holds up to cosmetic denting better than a 26-gauge one, and 22-gauge is stiffer again. Some insurers give a credit for a Class 4 roof, at a rate each one sets. Open lots also see more wind, so clip and fastener spacing tightens at eaves, rakes and ridges.
- Metal roofing systems with UL 2218 Class 4 ratings available, with the documentation insurers ask for
- Photo-documented roof inspections after hail and wind
- A written, itemized scope you can share with your adjuster
See how Class 4 impact-rated metal roofing works, what to do about hail damage and insurance claims, or compare standing seam systems and stone-coated steel.
Roof Systems for Sunnyvale Homes and Buildings
Most Sunnyvale roofs end up as one of three systems. On the large two-storey estates, 24-gauge standing seam in a PVDF finish makes sense, with every panel made to the full length of its slope so there are no end laps. On HOA homes that need texture, stone-coated steel does the job. And for the outbuildings that come with acre-plus parcels, whether a shop, a barn or a covered equipment bay, corrugated and PBR panels are the practical answer.
Standing Seam Roofs
Hidden-clip standing seam in 24-gauge Galvalume, aluminum, copper or zinc, with Kynar 500 finishes built for Texas sun.
Stone-Coated Steel
DECRA shake, shingle and tile profiles that keep a traditional look on Sunnyvale homes in HOA neighborhoods.
Metal Shingles and Shakes
EDCO and Classic Metal Roofing Systems shingle and shake profiles in colors that suit brick and stone.
Corrugated and PBR Roofs
Ribbed panels for barns, shops and porch roofs, cut to the length of each run before they reach the site.
Copper and Zinc Roofing
Copper accents over a porch or bay window, or a full zinc roof that weathers to a soft gray.
Metal Roof Repair
Repairs for standing seam, PBR, corrugated and metal shingle roofs, with the cause written down.
A free measurement turns a Sunnyvale roof into an itemized written estimate. Before that, the metal roof cost guide shows what drives the total.
Sunnyvale HOA Rules and City Permits for Metal
In Stoney Creek and most of Sunnyvale’s newer estate subdivisions, HOAs enforce strict architectural controls, so a review goes on the schedule before material is ordered. State law limits those boards somewhat. Under Property Code 202.011 they cannot refuse a shingle built for hail and wind resistance or energy savings if it resembles the approved roofs, will last longer and is of equal or better quality, though color and appearance remain theirs to decide. Stone-coated steel and metal shingles meet that test most directly, while standing seam goes before the board with color samples and a spec sheet. For every lot, we take care of any permit the town requires.
Sunnyvale Coverage Snapshot
| Counties | Dallas County |
| Residents | Roughly 9,000 |
| Typical home | median value $565,000; half built in 2006 or earlier (Census ACS 2020-2024) |
| From our base | About 5 miles from Mesquite |
| Roof systems | Standing seam, metal shingles and shakes, stone-coated steel, corrugated and PBR, copper and zinc |
| Services | New roofs, replacements, repairs and hail damage documentation |
| Estimate and warranty | Free, measured and itemized in writing; lifetime non-prorated limited warranty on PMRS standing seam, transferable one time |
The PMRS Difference in Sunnyvale
- A lifetime non-prorated limited warranty on PMRS standing seam roofs, transferable one time. See our warranties.
- Class 4 impact-rated systems and the product documentation insurers ask for.
- Your deductible stays your deductible. Texas law bars roofers from covering it, and we comply.
- HOA approval packages with product sheets and color samples.
- Metal roofing specialists since 2006, with our own crews on every job.
Sunnyvale Metal Roof Questions
Will the same crew roof my Sunnyvale house and my shop?
Yes. A detached shop, barn or equipment shed is a good match for an exposed-fastener panel, whether PBR or corrugated, and we make both ourselves and install them over purlins or decking. If you want the buildings to look like a set, the shop can share the house’s color or even its standing seam profile, with trim bent to fit.
What metal roof style flatters a Stoney Creek stone exterior?
Against stone, a dark standing seam roof in a low-gloss PVDF finish looks crisp, especially on tall gables. For more texture, owners pick a stone-coated shake or an aluminum shake like Country Manor Shake from Classic Metal Roofing Systems. At the estimate we hold the samples right up to your stonework, so you can judge them in place before deciding.
How quickly can someone come out to measure a Sunnyvale roof?
Quickly, because Sunnyvale is only about 5 miles from our Mesquite office. A person answers the office phone, and any message gets a callback the same business day. At the visit, the estimator measures the roof, checks decking and flashing, and writes up each system you are considering. Calendars fill after big regional storms, so getting on the list before spring helps.
Is the roof estimate in Sunnyvale really free?
Yes. We inspect the roof, check the decking and flashing, measure every plane, and send a written estimate that lists each line of the job. There is no charge and no obligation, and Sunnyvale is roughly 5 miles from our Mesquite base.
Close to Sunnyvale, Also on Our Schedule
- Balch Springs (6 mi)
- Heath (6 mi)
- Forney (7 mi)
- Rowlett (7 mi)
- Garland (9 mi)
- McLendon-Chisholm (10 mi)
The full list lives on our DFW service areas page, and the office details are on our Mesquite location page.
Book Your Free Sunnyvale Roof Estimate
Send the form for a written Sunnyvale estimate, or call (469) 466-2421 and talk it through with the company that forms and installs the roof.