Red Oak, TX metal roofs, formed and installed by PMRS
Red Oak Metal Roofs Built for the I-35E Hail Corridor
A 2-inch hailstone is the same size as the steel ball used in the UL 2218 Class 4 impact test, and stones that size fell on Waxahachie, Red Oak’s neighbor to the south, in May 2024. Permanent Metal Roofing Systems installs Class 4 rated stone-coated steel and metal shingles on Red Oak homes, along with standing seam, and puts PBR or standing seam roofs on shops and light commercial buildings. Red Oak is a northern Ellis County city, and the drive from our Mesquite office, I-20 to I-35E, runs about 22 miles.
- 20+ years of experience
- Lifetime limited warranty
- Free written estimates
Roof Types We See Around Red Oak
Meadow Springs, Hickory Creek and The Woods of Red Oak show the pattern: subdivisions built for commuters between the 1990s and the 2020s, reached from Ovilla Road or I-35E, filled mostly with brick-veneer houses under composition shingles, and new construction is still spreading across the east and south sides. Texas sun fades those shingles, curls them and strips their granules, and leaks usually begin at pipe boots, ridge vents and the step flashing where the roof meets brick. Single-storey hip roofs take 1.75-inch snap lock well. On HOA streets, a two-storey generally looks best in a stone-coated finish or an EDCO steel shake. The older houses near Live Oak Street can carry standing seam on both the main roof and the porch.
We serve Hickory Creek, Meadow Springs, The Woods of Red Oak and the Old Downtown blocks along Live Oak Street, plus homes near Pearson Park, Ovilla Road and Red Oak Road, and the I-35E corridor.
Red Oak Hail, Wind and Heat: What a Roof Faces
Northern Ellis County sits in a well-worn hail corridor, and two recent storms brushed Red Oak: in May 2024, 2-inch hail fell on Waxahachie next door, and on March 8, 2025, a wind storm swept across Ellis County. The UL 2218 impact test drops a 2-inch steel ball from a height of 20 feet, and to earn Class 4 a roof covering has to survive without a crack or rupture. That makes products rated Class 4 by their makers, DECRA’s stone-coated steel among them, a sensible pick. In a standing seam roof, choosing 24-gauge over a thinner panel cuts down on cosmetic dents, and any premium credit is your insurer’s call. Clips and trim fasteners go in tighter at the roof edges for spring wind.
- Impact-rated standing seam, stone-coated steel and metal shingle options
- Heavier 24-gauge panels that resist cosmetic hail dents better than thinner steel
- Clip spacing and fastening planned for Texas wind uplift
See how Class 4 impact-rated metal roofing works, what to do about hail damage and insurance claims, or compare standing seam systems and stone-coated steel.
Roof Systems for Red Oak Homes and Buildings
Red Oak jobs start with hail. On HOA two-storeys, the lead choices are stone-coated steel and metal shingles carrying Class 4 ratings from their makers. Single-storey homes and new builds suit 24-gauge snap lock standing seam. Owners of brand-new houses on the east and south sides sometimes replace the original shingles with metal before those shingles fail at all. Shops and outbuildings on the bigger lots get PBR, with trim bent in our shop in a matching color.
Standing Seam Roofs
A clean, modern roof with no exposed screws to back out, available with Class 4 impact-rated assemblies.
Stone-Coated Steel
Steel panels coated in stone granules for the look of shake, shingle or tile, with impact ratings from the manufacturer.
Metal Shingles and Shakes
Interlocking metal shingles that shed hail and wind and keep a cedar, slate or tile appearance.
Corrugated and PBR Roofs
Corrugated and PBR panels for homes, shops, barns, carports and porches around Red Oak.
Copper and Zinc Roofing
Copper accents over a porch or bay window, or a full zinc roof that weathers to a soft gray.
Metal Roof Repair
Loose fasteners, failed sealant and storm-damaged panels repaired or replaced one section at a time.
How much will it cost? That depends on size, pitch, profile, metal and tear-off, so we measure first. Our cost guide walks through the seven factors.
Red Oak HOA Rules and City Permits for Metal
Most Red Oak subdivisions built after 2005 have strong HOAs, so a roof change on a newer home usually needs architectural approval first. A state statute, Property Code 202.011, narrows what those boards can refuse: they may not forbid shingles made for impact resistance or better energy performance when the new roof resembles the approved shingles, lasts longer, is equal or better in quality and blends with surrounding homes. Color and appearance remain theirs to regulate. We back the application with manufacturer data sheets and samples, then obtain the City of Red Oak’s permit and schedule its inspections around the install.
Red Oak at a Glance
| Counties | Ellis County |
| Residents | Roughly 20,000 |
| Typical home | median value $366,000; half built in 2007 or earlier (Census ACS 2020-2024) |
| From our base | About 22 miles from Mesquite |
| Roof systems | Standing seam, metal shingles and shakes, stone-coated steel, corrugated and PBR, copper and zinc |
| Services | New roofs, replacements, repairs and hail damage documentation |
| Estimate and warranty | Free, measured and itemized in writing; lifetime non-prorated limited warranty on PMRS standing seam, transferable one time |
Built and Installed by One Company, in Red Oak Too
- Written, itemized estimates that spell out panel, gauge, finish, underlayment and trim.
- Our own installation crews, scheduled from our Mesquite office, never subcontractors.
- A lifetime non-prorated limited warranty on PMRS standing seam roofs, transferable one time. See our warranties.
- Class 4 impact-rated systems and the product documentation insurers ask for.
- Your deductible stays your deductible. Texas law bars roofers from covering it, and we comply.
What Red Oak Owners Ask About Metal Roofs
Does the City of Red Oak require a permit for a metal reroof?
Plan on it. Most cities in the area want a permit when a roof is replaced, so we look up Red Oak’s current rules for your address, file the application if one is required and book any inspection. Your HOA’s sign-off is a separate approval, and we usually get it moving first. For a house outside city limits, we confirm which rules apply there.
How does Waxahachie’s 2-inch hail compare with the Class 4 test?
Closely. A product earns UL 2218 Class 4 by surviving strikes from a steel ball 2 inches across, let fall from 20 feet, with no cracking or rupture. Real hail falls faster in wind and never strikes evenly, so the test is a benchmark rather than a promise. Still, a Class 4 roof has been tested with stones the size Ellis County saw in May 2024.
Should a brand-new Red Oak home get metal before its shingles fail?
It can make sense if you plan to stay. Builder-grade shingles on new east- and south-side homes are often the first thing hail ruins, and replacing them early with stone-coated steel or standing seam means the next storm meets a Class 4 roof. Talk to your HOA before ordering, and find out from your carrier whether an impact-rated roof lowers your premium.
Does PMRS repair metal roofs in Red Oak that another company installed?
Yes. We trace leaks at seams, screws, pipe boots and flashing on standing seam, PBR, corrugated and metal shingle roofs, whoever put them on, and explain the cause before we fix it.
More Cities Near Red Oak
- Glenn Heights (4 mi)
- DeSoto (6 mi)
- Lancaster (6 mi)
- Waxahachie (9 mi)
- Cedar Hill (10 mi)
- Duncanville (11 mi)
The full list lives on our DFW service areas page, and the office details are on our Mesquite location page.
Price a Metal Roof for Your Red Oak Property
A Red Oak estimate costs nothing and comes itemized, with straight answers on panel profile, color and timing.