Metal roof installation in Murphy, TX
Murphy Metal Roofs for Homes Built in the Same Boom
Murphy filled in quickly, so a large share of its composition roofs reached the 15- to 25-year mark at about the same time. Permanent Metal Roofing Systems swaps those worn shingles for flat-pan standing seam with a factory finish, the metal roof the city’s reroofing requirements name, built to handle the hail this part of Collin County sees. Small commercial buildings along FM 544 can be roofed in metal as well. Murphy is about 14 miles north of our Mesquite office. Our own crews do the installing, and every trim and flashing piece comes off the brake in our shop.
- 20+ years of experience
- Lifetime limited warranty
- Free written estimates
Matching a Metal Roof to Murphy Homes
Large brick two-storeys built from the 1990s into the 2010s fill Maxwell Creek, Rolling Ridge and the rest of Murphy, set on wider lots than many suburbs offer. Nearly every one started with composition shingles. Because the building boom was so compressed, a great many of those original roofs have now crossed the 15-year line together, and the oldest are past 25. On a big two-storey, age shows first as shed granules, curled tabs and cracked pipe boots, and the long ridges, tall gables and many valleys give water plenty of places to start. Standing seam in a muted factory color sits comfortably against that brick. The wide lots often hold a detached shop, which can take the same panel and color.
We serve homes in Rolling Ridge, Aviary, Ranch at North Hill and Maxwell Creek, near Murphy Central Park and along FM 544, on both the Wylie ISD and Plano ISD sides of town.
Murphy Hail, Wind and Heat: What a Roof Faces
Murphy lies in the corridor between Wylie and Sachse that took the worst of the April 11, 2016 storm, when baseball- to softball-size hail fell and a 4.25-inch stone was reported in southeast Wylie. On September 24, 2023, hail of 1.75 to 2.25 inches was reported a few miles to the south and southwest, in north Garland and Richardson. Two major hail events seven years apart make a strong case for impact-rated roofing. In standing seam, a 24-gauge panel takes dents less readily than a 26-gauge one. On tall two-storey roofs, closer clip spacing at eaves and ridges resists wind uplift.
- Metal roofing systems with UL 2218 Class 4 ratings available, with the documentation insurers ask for
- Photo-documented roof inspections after hail and wind
- A written, itemized scope you can share with your adjuster
See how Class 4 impact-rated metal roofing works, what to do about hail damage and insurance claims, or compare standing seam systems.
Our Metal Roofing Work in Murphy, TX
Because Murphy’s roofs are aging on one timeline, the system that matters most is one that suits both the city and the HOA: flat-pan standing seam in a muted factory color, presented to each board with samples and product data. For standing seam on these tall roofs, 24-gauge steel is our usual recommendation. Flashing bent in our shop for tall walls and long valleys completes the job, and a backyard shop can take the same panel as the house.
Standing Seam Roofs
Hidden-clip standing seam in 24-gauge Galvalume, aluminum, copper or zinc, with Kynar 500 finishes built for Texas sun.
Copper and Zinc Roofing
Copper accents over a porch or bay window, or a full zinc roof that weathers to a soft gray.
Metal Roof Repair
Loose fasteners, failed sealant and storm-damaged panels repaired or replaced one section at a time.
How much will it cost? That depends on size, pitch, profile, metal and tear-off, so we measure first. Our cost guide walks through the seven factors.
Premium Metal Roofing for Murphy Custom Homes
In Murphy, the city narrows the metal choices before any HOA does. Its reroofing requirements list composition, standing seam metal, terra-cotta or concrete tile and slate, in muted colors. For metal, only flat-pan standing seam with a factory finish in an approved color qualifies; bare galvanized or aluminum roofs, wood shingles and shakes, and the panel types used on agricultural or industrial buildings are ruled out. The old roof must also come off before the new one goes on, and every covering must carry at least a Class C fire rating. For a large brick two-storey on a wide lot, that points to a flat-pan panel in a muted PVDF color such as dark bronze or charcoal, laid out so the seams align from eave to ridge across every gable and dormer.
- Full tear-off to the deck, which the city requires before any new roof covering goes on
- Class C fire-rated roof assembly documented for the permit, as Murphy’s reroofing rules require
- Seams aligned from eave to ridge on every gable so the large roof reads as one surface
- Dark bronze, charcoal or another muted PVDF color sampled beside the home’s brick before submittal
Compare copper and zinc roofing, architectural standing seam and the warranties that come with each system.
Approvals Before a Murphy Metal Roof Goes On
You will find an HOA in almost every Murphy subdivision. State law sets the outer limits of what those boards can refuse: under Property Code 202.011, a shingle built mainly for hail and wind resistance or for energy savings is protected when it resembles the neighborhood’s roofs, has a longer life, is not of lesser quality and blends with the street. Because the statute speaks of shingles, and the city’s own reroofing rules allow only factory-finished flat-pan standing seam among metal roofs, a metal roof here goes through each committee’s normal review. We assemble the architectural request, samples and product data included, and file Murphy’s building permit whenever the city requires one.
Murphy at a Glance
| Counties | Collin County |
| Residents | Roughly 21,000 |
| Typical home | median value $556,000; half built in 2005 or earlier (Census ACS 2020-2024) |
| From our base | About 14 miles from Mesquite |
| Roof systems | Flat-pan standing seam with a factory finish in a city-approved color, as Murphy’s re-roof rules require |
| Services | New roofs, replacements, repairs and hail damage documentation |
| Estimate and warranty | Free, measured and itemized in writing; lifetime non-prorated limited warranty on PMRS standing seam, transferable one time |
The PMRS Difference in Murphy
- Class 4 impact-rated systems and the product documentation insurers ask for.
- Your deductible stays your deductible. Texas law bars roofers from covering it, and we comply.
- HOA approval packages with product sheets and color samples.
- Metal roofing specialists since 2006, with our own crews on every job.
- Panels and trim formed by PMRS in Mesquite or on site, so every piece fits the roof it was made for.
Metal Roofing in Murphy: Common Questions
My Murphy roof is about 20 years old. Replace it now or wait?
Look for the signs first: bare spots where granules have washed off, tabs that curl, or bruises from hail. If you see them, a free written estimate now lets you plan instead of reacting after the next storm, when every crew in the region is busy. Policies can also treat older roofs differently on a claim, so ask your agent how age affects yours.
Which metal roof is easiest to get approved in Maxwell Creek or Rolling Ridge?
Start with the city: its reroofing requirements allow one kind of metal roof, flat-pan standing seam with a factory finish in an approved color, so stone-coated or shingle-style metal needs the building department’s confirmation first. A dark bronze or charcoal near the neighborhood’s shingle tones is usually the easiest request to a board. Each committee sets its own process, typically a form, the product name, a color and a sample or photo. We assemble that packet, and nothing is formed or ordered until the written approval arrives.
Are Murphy’s steep two-storey roofs a problem for metal?
No. Steep pitches suit metal well, since water and debris shed quickly. The work is in safety setup and in detailing the many valleys and wall junctions on these roofs, which is why we bend valley, step and counterflashing to measure in our shop. Standing seam goes onto steep two-storey roofs routinely.
What should Murphy owners do first after a hailstorm?
Photograph the roof and any ceiling stains, then call us before signing anything. We document the damage with dated photos and measurements and write a scope for your adjuster. Your carrier decides coverage, and Texas law makes the deductible yours to pay.
More Cities Near Murphy
The full list lives on our DFW service areas page, and the office details are on our Mesquite location page.
Ready for a Permanent Roof in Murphy?
Send the form for a written Murphy estimate, or call (469) 466-2421 and talk it through with the company that forms and installs the roof.