Coppell, TX metal roofs, formed and installed by PMRS
Coppell Metal Roofing as Original Roofs Reach Replacement Age
Many of the upscale brick two-story homes that fill Coppell are now old enough to need a new roof, and their owners are looking past another layer of shingles. Permanent Metal Roofing Systems gives them a step up: DECRA shake and tile profiles, EDCO and Classic metal shingles, or snap lock standing seam, each installed by our own crews with flashing bent in our shop. Coppell sits against DFW International Airport at the northwest edge of Dallas County, with part of the city in Denton County; our Mesquite crews cover the roughly 24 miles along I-635.
- 20+ years of experience
- Lifetime limited warranty
- Free written estimates
Roof Types We See Around Coppell
Housing in Riverchase, Northlake Woodlands and much of the rest of Coppell dates from the 1980s through the 2000s. These are brick-veneer two-story homes with several gables and long valleys, roofed in composition shingles or, more and more often, impact-rated versions of them. As those first roofs wear out, the failures follow a pattern: thin valleys, cracked pipe boots, and flashing that pulls away at chimneys and second-story walls. A DECRA shake or tile profile in stone-coated steel holds the dimensional look the houses were drawn with, and a metal shingle from EDCO or Classic is a lighter alternative. When an owner is remodeling in a modern style, 1.5-inch snap lock in a matte PVDF finish turns a traditional brick elevation into a clean, contemporary one.
Our crews serve Old Town Coppell, Riverchase, Cypress Waters and Northlake Woodlands, and homes near Andy Brown Park, the Grapevine Springs Preserve, Belt Line Road, SH-121 and I-635.
Coppell Hail, Wind and Heat: What a Roof Faces
Coppell shares the northwest Dallas County hail corridor with its airport neighbor, and the May 28, 2024 derecho left damaged roofs and fallen trees throughout the city. With both hail and straight-line wind in play, owners here often compare impact-rated shingles with metal. On the metal side, the makers carry the rating: DECRA’s stone-coated steel and EDCO’s steel shakes are both listed by their manufacturers at UL 2218 Class 4. Standing seam relies on concealed clips laid out for uplift, and a 24-gauge sheet takes cosmetic dents less easily than thinner steel. If an insurance credit is part of your math, ask your carrier first, because each company sets its own.
- Impact-rated standing seam, stone-coated steel and metal shingle options
- Heavier 24-gauge panels that resist cosmetic hail dents better than thinner steel
- Clip spacing and fastening planned for Texas wind uplift
See how Class 4 impact-rated metal roofing works, what to do about hail damage and insurance claims, or compare standing seam systems and stone-coated steel.
Roof Systems for Coppell Homes and Buildings
Coppell is a replacement market. Houses from the 1980s through the 2000s need new roofs now, and owners want an upgrade rather than a repeat. On HOA streets, stone-coated steel and metal shingles get the most requests, since they keep a dimensional profile and their makers rate them Class 4 for impact. Standing seam suits remodels and contemporary additions. Because these are two-story homes, nearly every job here also gets new step flashing, wall flashing and chimney caps that we bend to fit.
Standing Seam Roofs
A clean, modern roof with no exposed screws to back out, available with Class 4 impact-rated assemblies.
Stone-Coated Steel
Steel panels coated in stone granules for the look of shake, shingle or tile, with impact ratings from the manufacturer.
Metal Shingles and Shakes
Interlocking metal shingles that shed hail and wind and keep a cedar, slate or tile appearance.
Corrugated and PBR Roofs
Corrugated and PBR panels for homes, shops, barns, carports and porches around Coppell.
Copper and Zinc Roofing
Copper accents over a porch or bay window, or a full zinc roof that weathers to a soft gray.
Metal Roof Repair
Loose fasteners, failed sealant and storm-damaged panels repaired or replaced one section at a time.
How much will it cost? That depends on size, pitch, profile, metal and tear-off, so we measure first. Our cost guide walks through the seven factors.
Coppell HOA Rules and City Permits for Metal
Most Coppell subdivisions from the 1990s and 2000s have HOAs, so a replacement usually starts with exterior review. State law gives owners a lever. Section 202.011 of the Property Code means a board typically has to allow storm-resistant or energy-efficient shingles that copy the look of the approved roofs, meet or exceed their quality and fit the block, though it keeps authority over color and appearance. A stone-coated shake that mirrors the current profile is often the quickest approval. We prepare the paperwork for your request and secure the City of Coppell permit where it is needed.
Coppell at a Glance
| Counties | Dallas County (also Denton) |
| Residents | Roughly 41,000 |
| Typical home | median value $560,000; half built in 1994 or earlier (Census ACS 2020-2024) |
| From our base | About 24 miles from Mesquite |
| Roof systems | Standing seam, metal shingles and shakes, stone-coated steel, corrugated and PBR, copper and zinc |
| Services | New roofs, replacements, repairs and hail damage documentation |
| Estimate and warranty | Free, measured and itemized in writing; lifetime non-prorated limited warranty on PMRS standing seam, transferable one time |
Built and Installed by One Company, in Coppell Too
- Written, itemized estimates that spell out panel, gauge, finish, underlayment and trim.
- Our own installation crews, scheduled from our Mesquite office, never subcontractors.
- A lifetime non-prorated limited warranty on PMRS standing seam roofs, transferable one time. See our warranties.
- Class 4 impact-rated systems and the product documentation insurers ask for.
- Your deductible stays your deductible. Texas law bars roofers from covering it, and we comply.
What Coppell Owners Ask About Metal Roofs
Coppell neighbors keep choosing impact-rated shingles. Why pick metal instead?
Both can carry a Class 4 label, so the real differences are lifespan and wind. An impact-rated shingle is still an asphalt product that dries out and sheds granules on roughly the same schedule as other shingles. A steel or stone-coated roof is built to stay on through many hail seasons. Owners planning a long stay usually find metal the better value; someone selling soon may not.
Our Coppell roof is original to a 1990s house. Is it time?
Probably close. Roofs put on in the 1990s and early 2000s here have been through decades of Texas heat and several hail seasons, and they often show worn valleys, cracked pipe boots and loose wall flashing before any leak appears inside. An inspection tells you whether you can plan the change calmly. If a storm has already damaged it, call your insurer before anyone starts work.
Which permit office handles a Cypress Waters home in Coppell ISD?
Although Cypress Waters students attend Coppell ISD schools, the development is part of the City of Dallas, so a building permit there comes from Dallas, not Coppell. We confirm the jurisdiction for your lot before scheduling and file with the right city. Any HOA or owner-association approval in Cypress Waters is a separate step that we help you prepare.
How long does a metal roof installation take in Coppell?
Most homes take a few working days once the panels are formed, depending on size, pitch, tear-off and weather. Your estimate includes a time frame, and our office keeps you posted on the schedule.
More Cities Near Coppell
- Grapevine (4 mi)
- Flower Mound (6 mi)
- Lewisville (6 mi)
- Farmers Branch (7 mi)
- Carrollton (7 mi)
- Southlake (8 mi)
The full list lives on our DFW service areas page, and the office details are on our Mesquite location page.
Price a Metal Roof for Your Coppell Property
A Coppell estimate costs nothing and comes itemized, with straight answers on panel profile, color and timing.